This project is read-only.

AssemblyInfo and Checking In / Out files

Jan 28, 2013 at 8:33 PM


I've been using the AssemblyInfo task but as it is always updating the files it copies from the workspace, the version number is always the same (I'm incrementing the revision). I noticed that another set of changes were merged with the AssemblyInfo task last June, and part of these introduced a GetFile, CheckOutFile and CheckInFiles action that can be added to the workflow.

I was just wondereing if there was a tutorial on the best place to put these in the workflow and how to actually use them with the task? As far as I'm aware, I need to build up a list of files, check them out, change the assmebly info, check them in and then let it continue to build.



Jan 28, 2013 at 11:41 PM
Edited Jan 29, 2013 at 9:55 AM

Also, I'm just wondering how you can get access to the $(BuildID) token from the Build Number?